Marantec Comfort 250 Operations Instructions download pdf (Page 32)

English Page 32

G. Display functions and programming possibilities

Learning of drive power:

Attention!

If the operator cuts out during the test run and LED 8 and LED 2

are flashing quickly (error number 10 / automatic cut-out):

• Set the automatic cut-out

• For this look up point 2:

Programming 2nd level, point 2 + 3.

• Travel the operator (with door engaged) completely and without interruption

two times from door position 'DOOR CLOSED' to door position 'DOOR OPENED'

and vice versa.

During these two learning travels the operator determines the maximum push

and pull force which is required to move the door. After two further complete

door travels the operator is definitely ready for operation.

These settings remain unchanged even if power supply is interrupted, but they

can, nevertheless, if necessary, be changed as described before.

Test:

• Press button 팬.

–> The door must open and travel to the 'door open' position, that has been

set by you.

• Press button 팫.

–> The door must close and travel to the 'door closed' position, that has been

set by you.

• Shortly press the button on your hand transmitter.

-> The operator moves the door to 'OPEN' resp. 'CLOSE' direction.

• Press the button on your hand transmitter again during the operator run.

-> The operator must stop

The next push onto the button causes the operator to run in the opposite direction.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 87 88

No comments

Marantec Comfort 250 Operations Instructions Page 32